SP Racing F3 Flight Controller Deluxe version 10 DOF for Multicopter, Compass, Barometer

SPRacing F3 Flight Controller Deluxe Version runs Cleanflight and suits the Drone Racers who need all the features that have been specially designed for racing.

SP Racing F3 Flight Controller (SPRacingF3) has been designed to deliver incredible flight performance based on proven and tested sensors while additionally providing unparalleled and I/O capabilities in a small and extremely lightweight form-factor using a next-generation CPU.

Acro Version have 6 DOF while Deluxe version has 10 DOF, including Barometer and Compass: Additional sensors for altitude and direction

The SP3 Controller is favoured amongst some of the top pilots for its performance , reliability and black box recordings .

Flight Performance - The SPRacingF3 builds on tried and tested software, processor and sensor technology to make your aircraft fly like it's on rails.

Flight Logging - On-board high-capacity black box flight log recorder - optimize your tuning and see the results of your setup without guesswork.

Developer Friendly - Developer friendly debugging port (SWD) and boot mode selection, unbrickable bootloader.

No-Compromise I/O - Use all the features all the time; e.g. Connect your OSD + SmartPort + SBus + GPS + LED Strip + Battery Monitoring + Sonar + 8 motors - all at the same time!

Tiny and Lightweight - The SPRacingF3 has a standard 36x36mm form-factor with 30.5mm mounting holes and weighs just 6 grams.

Next Gen CPU - Full support for OneShot ESCs for easy PID tuning and a sharper response.

Broad RC Receiver Support - Supports SBus, SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers. No external inverters required (built-in).

Battery Monitoring - Ports to enable monitoring of voltage and current.

12C Port - I2C port always powered, perfect for external sensors or always-on OLED Screen.

Programmable LED - Dedicated output for programmable LEDs - great for orientation, racing and night flying.

Buzzer - Buzzer port for audible warnings and notifications.

Specifications of the Flight Controller.

•     36x36mm board with 30.5mm mounting holes
•     Weight ~6 grams
•     STM32F303 CPU, 72Mhz inc FPU
•     High-Capacity Flash (Acro and Deluxe)
•     MPU6050 accelerometer/gyro
•     MS5611 barometer (Deluxe only)
•     HMC5883 compass (Deluxe only)
•     MicroUSB socket
•     2x 8pin JST-SH sockets (PPM, PWM, SERIAL RX, GPIO, ADC, 3V, 5V, GND)
•     8x 3pin though-holes for pin headers for ESC/Servo connections
•     2x 4pin though-holes for pin headers for 2x serial ports
•     1x 2pin though-holes for pin headers for battery voltage
•     1x 2pin though-holes for pin headers for buzzer
•     1x 4pin JST-SH socket for I2C
•     1x 4pin JST-SH socket for SWD debugging

Package including Case, Pins, Cables for connections